8000 series rubber oil coating

Features:

8000 series rubber paint has as soft rubber-like, flexible, transparent color, and has very soft sand matte surface gloss, with a variety of color primer on different substrates and chromogenic substrates showed different results, with excellent layers Adhesion between good flexibility, good stain resistance, high hiding power, good scratch resistance, a very excellent leveling effect and excellent elastic feel. Especially for frequent hand contact with the high-grade products.

Scope: Applicable to all kinds of plastic & rubber electronic, metal, wood and other surface coating. Sports equipment, communications products, audio-visual products, MP3, household supplies, cell phone case, decorations, decorative boxes, car interior, microphone, gifts, household appliances, computer peripheral products, electronic products, such as Shell.

Resin type: modified linear copolymer containing special micro-branched structure.

The main technical parameters:

Substrate treatment: When applied to metal products, the must first spray paint primer for PP plastic & rubber, PP bottom water must first spraying

Coating way: manual spray suitable for general

Hardener: N600 series curing agent

Thinner: T-430

Mixing ratio: Paint 8103A: hardener N603: Thinner T-430 = 10: 1: 3

8200 paint: hardener N603: Thinner T-430 = 10: 1: 3

8300 paint: hardener N605: Thinner T-430 = 10: 1: 3

Dilution ratio: based on actual customer requirements dilute spray viscosity recommended diluent ratio of 10: 3 (weight ratio) or spray viscosity of 8-11 seconds (25ºC / Iwata 2 viscosity cup)

Precautions:

1, first Stir well before use

2, the substrate surface should be cleaned before spraying stains, dry to ensure adhesion coefficient

3, the paint is allowed to stand for 5 minutes with a good mix, with 200-400 mesh filter and then spraying

4, compressed air and a variety of instruments to be dry, clean

5, the pressure 4KG / CM 2, gun distance 10-20CM, spray gun two or more times.

6. If you need to test the overall performance need to add more than bake 8h.

7, since the NT-70 curing agent curing long-term exposure to air will lose its effectiveness, after each use with a solvent must lids and mouth before washing tank cover, otherwise it will solidify cause can not be used.

After the spraying members need put into 5-10 minutes before they were placed in a drying oven to dry, with 70-80ºC baked 30 minutes, temperature and time must be met, otherwise the film is not completely dry, reduce hand and anti-scratch sex.
8, due to the two-component elastic rubber paint paint, curing agent need painting, so diluted oil at room temperature and the air will have a certain pot life, we advise you to open the oil is not too much, open and good oil After over two hours using the most appropriate.

Packing: 3.5KG canned

Security Code:

1, flammables, do not close the fire;

2, the construction, we must pay attention to ventilation;

3, other usage guidelines, refer to "Material Safety Data Sheet."